The EP Greenhouse gearbox is a concise and lightweight reduction geared motor with a limit switch system that’s ideal for assembly of a locally available electric engine. The geared motor is used in manually-controlled or climate-controlled ventilation and display systems in greenhouses. The quick and easy-to-install EP geared motor is certainly rainproof and windproof. The geared motor includes a high protection course (IP65) and can be utilized in an ambient temperature of 0-60 °C.
The low-noise gear motor for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny means that the 
drive shaft can be locked when the reduction geared motor is not running. The completely sealed reduction geared motor has an expansion chamber with a diaphragm to keep carefully the gear oil at a low pressure under all circumstances, even at high temperature ranges. Thanks to the utilization of an growth chamber, the reducer can be installed in any placement. There are no restrictions, because there is no need for a bleed connect. The sealed reduction geared motor keeps the gear oil of the gear reducer in ideal condition because of its entire operating lifetime. The reducer is ideal for discontinuous use, working course s3-30%, with a maximum activation time of 25 minutes.
The Gear box reduction gearbox comes with an FT85 motor assembly flange, to which the right IEC standard motor can easily be installed (EN 50347).
The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off by the end positions. The limit change system is installed in an included chamber and is certainly enclosed by an impact-resistant plastic cover. The limit change system is accessible and simple to adjust. The limit change system’s optimum switching range can be 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The gear motor has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The gear driver for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.
Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of program of 4-pole electric motor.
Protection class IP65.
Can be used in ambient temperature ranges of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, maximum activation time 25 a few minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC regular motor (EN 50347).
Maximum switching range of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).