Gear Boxes For Rotary Cutter’s, Shredders, and Choppers
RC 30 Collection Gearbox, 40hp Rated, one-3/8″ SB input, one-1/two” X twelve Spline Output. 1:one.47 Ratio Change your damaged rotary cutter gearbox with this replacement unit. Why rebuild when you can replace at these kinds of a low value? These gearboxes have been employed by Worksaver, HawkLine, International, WAC, Large Bee, LMC, King Kutter, Midwest, Servis, Bush Hog, some Howse and several more. Notice: Actual Gearbox could have a rounded housing or sq. as proven, relying on current availability, all internal components are interchangeable and specifications for each boxes are similar! This gearbox attributes a 1:one.forty seven Speed Up gear ratio for use on 5′ and bigger diameter rotary cutters. Market standard one-three/eight” smooth diameter input shaft with one/two” shear bolt gap and retaining ring groove and 1.57″ diameter 12 tapered spline output shaft allow fitment to most light, common and medium duty rotary cutters. Each gearbox functions high speed ball bearing units and heat treated gears and shafts to ensure extended life. 4 bolt mounting matches market requirements. Each gearbox consists of blade carrier mounting nut and cotter pin. Gearboxes are shipped dry and need sixteen ounces of 80-90W gearlube or equivalent. Disclaimer: Any and all First Products Manufacturer’s (OEM) tradenames, emblems, drawings, shades, descriptive data and component quantities are utilized for areas identification purposes only, and DN Gear, LLC (DN) is in no way implying that any specific parts are OEM parts. Additional, any use of the OEM’s tradenames, emblems, drawings or portion figures by DN is created only to support DN’s consumers, in getting the correct DN component or part which will substitute the OEM’s portion.
rotary cutter gearbox
Gearboxes function to administer a transfer of speed and torque by means of their interior equipment rotation, aiding the overall performance of your rotary cutter. This RW-710-6S gearbox operates at seventy five-ninety HP. The housing is built from tough ductile iron and the input shaft actions 1-3/8 in., with six splines. It has a gear ratio measuring 1:1.46, and is created for use with 5 ft., six ft., and 7 ft. rotary cutters. Far more measurement and a lot more HP method you should make contact with us for particulars.